Strav's blog

Attached is the pinout for the NodeMCU WiFi enabled Arduino module.

Pinout was found here

Amazon link to the NodeMCU is here

Here are some links to DIY Washer/Dryer pedestals

How to build a front load washer and dryer pedestal stand
Washer and Dryer Pedestals
Build Your Own Washer and Dryer Stand
Spout Dispenser Build (From Washer and Dryer Stand Video)

We are (I am) installing LVP in the house for all the floors. Here are a number of links to LVP installation guides, tips and tricks.

How to install laminate flooring without room transitions
How To Install Vinyl Plank Flooring
So That's How You Do That Website
How to avoid transitions when installing laminate or vinyl plank by installing planks backwards
How to install the last few rows - installing laminate and vinyl plank
Tips for Installing Your LVT (Luxury Vinyl Tile)
Vinyl Plank Transition to a Thick Tile
How to install laminate or vinyl plank to a tub
How to make a cheater board - Laminate or vinyl plank installation

Here are numerous threads regarding cabinet painting, rebuilding and otherwise refreshing.

Painting:

How To Paint Or Refinish Kitchen Cabinet Doors. Cabinet Painting Hacks.
How to Paint Kitchen Cabinets the Right Way | withHEART
How To Paint Oak Cabinets
How to Paint Kitchen Cabinets - This Old House
How To Paint Cabinets The Easy Way!
6 Secrets to Silky Smooth Paint
Spray cabinet doors
How To Paint Your Kitchen Cabinets Without Losing Your Mind

Soft Close Slides and Hinges:

How to make a soft closed drawer slide swap

I have 2 DS-380 builds with both using the following hardware:

DS-380 case
SilverStone 450W SFX Form Factor 80 plus gold PS
ASRock Intel Avoton C2750
Kingston ValueRAM 8GB 1600MHz DDR3 Non - ECC CL11
SATA III Cable, CableCreation 18-inch SATA III 6.0 Gbps

There are a couple reference posts from forums here:

[COMPLETED] Daniel's Home Setup (**UPDATED 14/01/2016**)
Silverstone DS380 thread?
price nearly equal - Lian-Li PC-Q25B vs. DS380
Silverstone DS380 NAS Chassis Review SFF Silverstone DS380 Build

shroud dimensions are listed in some of the the posts above. For quick/easy/forever reference, they are: Length: 275mm Width: 57mm (Note: the last case I received needed the Width to be ~78mm with a notch on both ends for cable routing and a notch ~1/3 from the top for the PCIe bracket)

Additionally, someone has created a 3D printed shroud: Creating a Cooling Duct for the SilverStone DS380B